FREJA549

The most common form of communication used with the FREJA units is via ethernet. If you cannot establish communication, it is important to check that RTMS is enabled in the local firewall. Sometimes the antivirus installed on the computer will block ethernet communications to the FREJA. Another possible reason for the failure to communicate is that the IP addresses of the unit and the PC are not on the same subnet. Changing the IP address of the FREJA or the PC to be on the other’s subnet will fix the issue. We recommend configuring the FREJA in DHCP mode so that it takes an IP address in the same subnet as the PC connected to it. If the FREJA’s IP address has been set to a fixed value, it is possible to force the unit into DHCP mode using RTMS.
When serial communication, such as USB or Bluetooth, fails, the culprit is usually the port number used, which you can check on the device manager.

The Bluetooth pairing code is a standard default of 0000 (four zeroes).

Things to check:

• In the FREJA/RTMS
  • Is the binary input on the FREJA configured as wet or dry contact? Does it correspond with the relay’s binary output’s operation?
  • Is the type of operation properly selected? i.e. “Normally Closed” or “Normally Open” contact?
  • Is the trip input properly selected? Sometimes the FREJA is connected to the proper output on the relay, but RTMS is expecting the trip input on a different channel.
     
• In the relay:
  • Is the test signal used adequate for the test? For example, if a 51 pickup is being tested, the timing signal cannot be used to trip and vice versa.
  • Is the trip properly assigned to the output on the relay?
  • Is there any condition blocking the trip inside the relay?
  • Is the proper polarising signal being used?

In the FREJA units, the battery simulator doubles as the fourth voltage channel. For this reason, seeing the four voltage channels on the home screen indicates that the battery simulator is not activated. If that’s the case, go into the configuration screen by clicking on the “gearbox” button and click on the “Use Last V as Battery” button. When you return to the home screen, you’ll see that you no longer have a fourth voltage channel available, and the battery icon has been enabled.

For each test, the RTMS report provides a visual indication of the status of the results. Results status may be either not performed, incomplete, failed, or passed.

The RTMS evaluates the report and provides a pass or fail status based on whether all the tests have passed (or not). All the tests must have a passed status for the report to have a passed overall status. Each test is time-stamped, indicating the date and time when the test was performed.

Each test is evaluated using criteria specific to the test. For some tests, you can set the tolerances directly in the report. In contrast, for others, they must be set inside the test form before performing the test. The specific values for the tolerances used are your responsibility. You can find these in the relay's manual or select tolerances from the local test procedures.

The overcurrent curves are built around a pickup value, a time dial, and a curve type. They are sometimes affected by the election of an electromechanical reset. Those are the first things to check if the times are not correct.

If the curve followed by the results is like the target relay curve, but the times are lower than those of the target curve, then perhaps the issue is that we have selected a higher time dial than that of the relay. Another reason for lower times could be the choice of pickup value. If, for the test, we choose a pickup value higher than that of the relay, then the times will also be lower.

If the form of the results curve is different, then the type of the curve could be the reason. If there is an electromechanical reset or if we are testing an electromechanical relay, we must provide enough time between consecutive test points. This extra time will allow the relay to fully reset or return to the zero position before injecting current again.

Sometimes an instantaneous element is also inadvertently tripping on the same contact. This situation should be easy enough to verify since the trip times will be very low. In this case, testing for multiples below the pickup of the instantaneous will fix the issue.