SPI225
SISTEMA DE PRUEBA DE INYECCIÓN PRIMARIA SMART | SPI225
Acerca del producto
- Hasta 2000 A de salida
- El sistema de prueba de inyección primaria más pequeño de su clase
- Primer unidad en el mercado para eliminar el control por variac
- Regulación de la corriente de salida
- Diseñada para puesta en servicio de conmutadores, interruptores, puesta en servicio de transformadores de corriente, mallas de tierra y prueba de relés
- El software incluye miles de interruptores de Curvas TCC
El modelo SPI225 es un sistema de prueba de inyección primaria de alta corriente para todas las formas de pruebas de alta
corriente requeridas en una subestación, que incluye la prueba de relés de sobrecorriente, interruptores, sobrecarga de motores y transformadores de corriente.
Especificaciones técnicas
- Max output current (AC)
- 2000 A
- Output type
- Automatically regulated
Ver más detalles en la hoja de datos del producto
Documentos del producto
Software y firmware
SPI225
Installation Instructions
USB Memory Stick:
- With the SPI and STVI powered up, insert the USB memory stick into the USB port on top of the STVI.
- Press the Configuration Screen button, and then press the Update Firmware button in the Configuration Screen.
- At that point the user will be presented with the IP Address selection screen, with the serial number of the unit. Select the unit by touching the serial number and the upgrade process will automatically start. That’s all there is to it.
- Observe the STVI display screen, and the unit. At the completion of the download, there will be an instruction to reboot (turn off and back on) the test system.
PC and STVI Software:
- If using the PC version of the STVI software, it is very similar to the STVI. Upon clicking on the Update Firmware button, the familiar Windows Open File browser dialog box will appear.
- Using the Look In pull-down menu, navigate to where the new firmware was downloaded onto the PC, click on the file SPI_Firmware__X.XXX.ldr (SPI Loader).
- You will be requested to select a unit from the IP Address screen. Select the unit by clicking on the serial number and the upgrade process will automatically start.
- At the completion of the download, there will be an instruction to reboot (turn off and back on) the test system.
- Note that after rebooting the SPI unit, if using the PC version of the STVI software you will have to restart the STVI software on your PC in order to regain control of the SPI unit
PowerDB Software
Onboard install files are for FREJA, RTMS, SMRT and STVI local device installation.
PC install is for remote operation of a wide range of Megger test instruments including FREJA, RTMS, SMRT, STVI and BITE5.